Operating Instructions - Auvon AS1080 Bedienungsanleitung

OPERATING INSTRUCTIONS

1. Connect the pads to the wire by snapping them on,then
remove the protective film.
Note: adding a few drops of water on the pads will increase
their longevity.
2. Place pads where the massage sensations are desired.
Plug into one of the ports on the device. For additional
relief use the second port and repeat procedure to put on
another two pads. Make sure both pads on the skin and not
overlapping. Make sure your skin is free from any dirt, oil or
lotion.
3. Turn the device on by sliding the on/ off switch on the top
of the unit.The unit will be now activated.
4. Press the mode button to try different modes.
Then press the center button to choose the waves within
that selection.
Remember the strength will default to the lowest setting by
each mode selection.
Note: Center button can also be used as a lock key. Press
and hold it for 3 seconds to lock the screen, 3 seconds
again to unlock the screen.
5. Once you select a mode, gradually increase the intensity
by pressing the + button; decrease it by pressing - button.
6. Recommended application is 10-60 minutes. Increase 10
minutes by each setting. The time remaining is automatically
counted down. Then the unit will automatically turn off after
time finish.
AFTER USE
1.Turn off the device on by sliding the on/ off switch on the
top of the unit.
2. Remove lead wire pin from electrode connector by
gently twisting and pulling it out.
Support@iauvon.com
20
UK