Cisco Systems Linksys WMP54G Schnellinstallationsanleitung Seite 191

Wireless-G PCI Adapter
Setting Up the Adapter with Available Networks
If you're not setting up the Adapter with Secure Easy Setup, another method for setting up the Adapter is with the
available networks listed on the Available Wireless Network screen. The available networks are listed in the table
on the center of the screen by SSID. Select the wireless network you wish to connect to and click the Connect
button. (If you do not see your network listed, you can click the Refresh button to bring the list up again.) If the
network utilizes wireless security, you will need to configure security on the Adapter. If not, you will be taken
directly to the Congratulations screen.
1. If wireless security has been enabled on this network, you will see a wireless security screen. If your network
utilizes WEP (Wired Equivalent Privacy) encryption, the WEP Key Needed for Connection screen will appear. If
your network utilizes WPA-Personal (Wi-Fi Protected Access) encryption, the WPA-Personal Needed for
Connection screen will appear. If your network utilizes PSK2 (Pre-Shared Key 2) encryption, the PSK2 Needed
for Connection screen will appear.
WEP Key Needed for Connection
Select 64-bit or 128-bit.
Then, enter a passphrase or WEP key.
Chapter 4: Using the Wireless Network Monitor
Creating a New Profile
All manuals and user guides at all-guides.com
Figure 4-22: Available Wireless Network
Figure 4-23: WEP Key Needed for Connection
33