Adjusting The Reversing Camera; Installing The Lcd Monitor; Operation - AEG 4.3 Bedienungsanleitung

Attention!
The location of the camera brackets
may not impair the functionality of the
license number light! If it impairs the
license number light mount the camera
on the opposite side�
4� attach the mounting plate and the
number plate holder to the vehicle�
5� attach the number plate�

Adjusting the reversing camera

The reversing camera can be swivelled
in one direction�
1� To adjust the reversing camera,
loosen the screws at the bottom of
the reversing camera�
2� swivel the camera into the desired
position�
3� Tighten the screws�

Installing the LCD monitor

Attention!
The location of the monitor may not im-
pair the visibility of the driver! further,
do not impair the functionality and
operation of equipment, control units
and systems inside the vehicle� follow
applicable laws and safety regulations
for vehicles!
1� Clean the area of the windshield
where you would like to attach the
suction cup base�
2� Press the suction cup against the
windscreen and push the locking
lever toward the suction cup�
3� Insert the monitor mount of the
monitor arm (15) into the designated
opening at the back of the monitor�
4� slide the monitor bracket up until it
locks in place�
5� open the locknut and adjust the
monitor to a comfortable angle�
Then tighten the locknut again to
fix the monitor.
6� Connect the monitor cable (16) to
the monitor and the 12 V vehicle
socket� route the monitor cable
so it does not impair or jeopardise
the safety of the vehicle and its
occupants�
•
remember the vehicle's battery will
be discharged when the vehicle is not
running�

oPeraTIon

Warning!
Do not operate the monitor whilst driv-
ing, as this distracts from traffic. Main-
tain your focus on driving and traffic.
attention!
In extremely bright conditions the
monitor will take a few seconds to ad-
just to the light conditions� Wait for the
image to stabilise before reversing�
English 31