Care And Cleaning - AEG DPE5660M Benutzerinformation

34 www.aeg.com
The fan does not operate
during the alarm. Fan starts
to operate on last
remembered setting after 30
seconds.
Refer to cleaning the grease
filter in care and cleaning
chapter.
Refer to cleaning the
charcoal filter or replacing
the charcoal filter in care and
cleaning chapter.
The function counter for
charcoal filter is disabled by
default.
To activate or deactivate the counter
for charcoal filter:
1. Pull out the hood drawer.
2. Make sure that the fan is turned off.

4. CARE AND CLEANING

4.1 Notes on cleaning
Cleaning
Agents
Keep the hood
clean
Charcoal filter
Do not use abrasive detergents and brushes.
Clean the surface of the appliance with a soft cloth with warm water
and a mild detergent.
After cooking some parts of appliance can get hot. To avoid stains ap‐
pliance must be cooled down and dried with clean cloth or paper tow‐
els.
Clean stains with a mild detergent.
Clean the appliance and grease filters each month. Clean the interior
and grease filters carefully from fat. Fat accumulation or other residue
may cause fire.
Grease filters can be washed in a dishwasher.
The dishwasher must be set to a low temperature and a short cycle.
The grease filter may discolour, it has no influence on the performance
of the appliance.
The time of saturation of the charcoal filter varies depending on the
type of cooking and the regularity of cleaning the grease filter.
3. Press for 3 seconds.
The function is activated if two white LED
indicators flashes for 3 seconds. The
function is deactivated if only one LED
indicator flashes for 3 seconds.
To reset the function counter in the
notification period:
1. Pull out the hood drawer.
2. Press for 3 seconds.
To reset the function counter out of
the notification period:
1. Pull out the hood drawer.
2. Make sure that the fan is turned off.
3. For grease filter press
seconds.
4. For charcoal filter press
seconds.
The indicator blinks once for correct
reset.
for 3
for 3