Safe Installation; Installation En Toute Sécurité - NEFF T17TT76N1 Montageanleitung

Kochfeld ausbauen
Das Gerät spannungslos machen.
1.
Das Kochfeld von unten herausdrücken.
2.
en

Safe installation

Follow these safety instructions when in-
stalling the appliance.
¡ Electrical connection must only be carried
out by a licensed expert. Incorrect con-
nection will invalidate the warranty.
¡ The safe operation of this appliance can
only be guaranteed if it has been installed
to a professional standard in accordance
with these installation instructions. The in-
staller shall be liable for any damage res-
ulting from incorrect installation.
WARNING ‒ Danger: Magnetism!
The appliance contains permanent mag-
nets. They may affect electronic implants,
e.g. pacemakers or insulin pumps.
▶ Persons with electronic implants must
stand at least 10 cm away from the appli-
ance.
Built-under
Do not install refrigerators, dishwashers, non-ventil-
ated ovens or washing machines underneath the ap-
pliance.
¡ If you fit a modular or compact dishwasher of the
same brand underneath the appliance, the work-
top must be at least 40 mm thick.
¡ If you fit an oven below the appliance, the worktop
must be at least 20 mm thick, in certain cases
even thicker. Observe the information in the oven
installation instructions.
¡ Make sure that projecting parts such as the mains
housing or the mains cable do not collide, e.g.
with a drawer.
Intermediate floor
If the underside of the hob can be touched, an inter-
mediate floor must be fitted.
¡ Ask your specialist retailer for an intermediate
floor as an accessory.
¡ If you use your own intermediate floor, the min-
imum distance to the mains connection of the ap-
pliance must be 10 mm.
Preparing the units
The worktop must be level, horizontal and stable.
¡ The fitted unit must be heat-resistant to at least
90 °C.
¡ Seal the cut surfaces with heat-resistant material.
→ Fig.
1
Inserting the hob into the wider cut-out
Create the wooden battens in accordance with the
1.
drawing.
Check and adjust the cut-out dimensions.
2.
Screw the wooden battens in place so that they
3.
are flush with the upper edge of the worktop. For
stone work surfaces, bond the wooden battens in
place.
→ Fig.
2
Installing fixing rails
For stone work surfaces, bond the fixing rails in
place.
→ Fig.
3
Electrical connection
Check the household wiring before connecting the
appliance.
¡ The appliance fulfils the requirements of protection
class I and must only be operated in conjunction
with an earth conductor.
¡ In the permanent electrical installation, a partition
must be provided in the phases in accordance
with the installation regulations.
¡ If appears on the appliance's display, it has
not been connected correctly. Disconnect the ap-
pliance from the mains and check the connection.
Connecting without a pre-installed cable
Only connect the hob in accordance with the con-
nection diagram.
¡ If required, install the enclosed copper bridges.
¡ The power cable must correspond to
type H05 VV-F or a higher rating.
¡ Use the current load to determine which wire
cross-section you require. A cross-section of
< 1.5 mm² is not permitted.
Installing the hob
Do not trap the power cable and do not route it over
sharp edges.
¡ If the oven is a built-under type, route the cable
along the rear corners of the oven to the mains
socket.
¡ Push the hob in until it locks into place.
→ Fig.
4
Removing the hob
Disconnect the appliance from the power supply.
1.
Push out the hob from below.
2.
fr
Installation en toute
sécurité
Respectez les consignes de sécurité
lorsque vous installez cet appareil.
¡ Branchement électrique uniquement par
un spécialiste agréé. Toute erreur de
branchement annule la garantie.
¡ Seule une installation effectuée selon la
présente notice de montage garantit une
utilisation en toute sécurité. L'installateur
est responsable en cas de dommages
dus à une installation incorrecte.
AVERTISSEMENT ‒ Danger :
magnétisme !
L'appareil contient des aimants permanents.
Ceux-ci peuvent influer sur des implants
électroniques, par exemple des stimulateurs
cardiaques ou des pompes à insuline.
▶ Les personnes portant un implant électro-
nique doivent donc respecter une dis-
tance minimum de 10 cm avec l'appareil.
3