ENGLISH
Read these instructions carefully before use!
•
Disconnect the mains voltage before starting installation.
•
The bulb gets very hot when it is switched on. Wait until it has cooled before touching it. Do not
touch bulbs with your bare hands.
•
Do not use the lamp without the entire lamp shade in place.
•
Be careful not to exceed the stated rated output of the bulb (60 W).
The lamp must be connected to a properly earthed power outlet.
•
The power cord must be type H05RN-F 3G, 1 mm
•
Install a double pole switch.
•
WARNING:
Do not use the lamp post if the power cord and/or plug are damaged in any way. For safety
•
reasons, the power cord must only be replaced or repaired by an authorised service centre.
Consult your dealer.
Component
A: Triangular support
B: Anchor rod/bolts
C: Base
D: Lower post unit
E: Upper post unit
F: Lamp
SAFETY INSTRUCTIONS
TECHNICAL DATA
Mains voltage
Rated output
Safety class
Protection rating
Base
DESCRIPTION
Qty
ENGLISH
, or stronger.
2
220 – 230 V/50 Hz
Max. 60 watts
I
IP44
E27
External mains wires
Component
1
I1: Washer for bolt M10
3
I2: Screws M6 x 16
1
I3: Screws M5 x 10
1
I4: Screws M5 x 5
1
Terminal block (not supplied)
1
Hex key for M3
Hex key for M4
Spring washer under M10
9
Internal
mains
wires
Qty
3
3
3
3
1
1
1
3