Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Fig. 1
CLEANING AND MAINTENANCE
1. Before cleaning, switch off the appliance and unplug it.
2. Open the appliance to take out the HEPA filter. Wipe off the dust on the filter by a brush carefully over a
trash can. If necessary, hit the mesh cover of the filter to clean the dust on the surface of the filter. If dust
is accumulated too much, take down the filter from the cover (see reference on section "Replacement of
the HEPA filter") and clean the filter from inside to outside by clear water. The filter cannot be used again
until it is dry.
3. Empty the dust container. Pour the dust into the trash can. Clean the dust on the inner wall of the dust
container. If necessary, use a wet cloth to wipe the surface of the dust container.
4. After cleaning, assemble the appliance again.
Note: Empty and clean the appliance before and after vacuuming to avoid the collection of materials that
could cause a fire hazard in the appliance.
Replacement of the HEPA filter
1. Turn the cover upside down. Loosen the butterfly nut anticlockwise. (Fig. 6)
2. Hold the cover to shake the filter, letting the filter leave the fixed bottom. Then hold and pull the filter
upwards. (Fig. 7)
3. Take a new filter and press it into position. Make sure the hole on the filter should go through the fixed
bolt. (Fig. 8)
4. Fix back the butterfly nut. (Fig. 9)
5. Place the cover back. Fasten the dust container with the cover firmly by the container lock tabs. (Fig. 10)
Fig. 6
Fig. 9
Fig. 2
Fig. 7
Fig. 10
- 11 -
Fig. 3
Fig. 4
Fig. 8
Fig. 5
Werbung
