Inhaltsverzeichnis
Werbung
Valve fine adjustment
1.) Adjustment of the valve on the right-hand side: At first, bring the lever at the drawbar to the
lowermost position (lifting) and unscrew the adjustment screw from the valve. The same is fixed by a
locking nut seated on the adjustment screw. Now, it should be possible to pump up the platform floor
truck. Now you can set the lifting procedure by fine adjusting the valve.
2.) Bring the lever at the drawbar to the centre position (neutral) and slowly screw in the adjustment screw until
the platform floor truck does not lower and does not lift either. Fix this point by using the nut.
Warranty
Genuine parts and accessories
Please use genuine HanseLifter® parts for your HanseLifter® platform floor truck only. Installing spare parts
and accessories of other manufacturers is not checked and approved by us and, thus, may have adverse
effects on the properties of the device. The manufacturer shall not assume any liability for damages resulting
from the installation of non-genuine parts and accessories. Furthermore, the warranty will forfeit if spare parts or
accessories are installed in an unauthorised manner by third parties.
HanseLifter® recommends
Tightening torques
Dimension
M 6
M 8
M 10
M 12
M 14
M 16
M 18
M 20
M 22
M 24
M 27
M 30
M 36
Note:
•
Use screws of strength class 8.8 for all load-carrying and important parts only.
•
The strength classes are listed in the table above
SDJ10 – Series
®
products.
4.6
4-5
10-12
12-15
20-25
25-31
35-44
44-54
54-69
69-88
88-108
108-137
118-147
147-186
167-206
206-265
225-284
284-343
294-370
370-441
441-519
539-686
529 - 666
666 - 833
882 - 1078
1098 - 1372
Table 4 Tightening torques
Duplication, even in parts, is not permissible.
Tightening torque (Nm)
5.6
6.6
5-7
6-8
14-18
29-39
49-64
83-98
127-157
176-216
245-314
343-431
441-539
637-784
784 - 980
1323 - 1677
8.8
9-12
22-29
44-58
76-107
121-162
189-252
260-347
369-492
502-669
638-850
933-1244
1267 - 1689
2214 - 2952
Page 13 of 22
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
