Technical Data - Zgonc yellow ProfiLine YPL 711 Bedienungsanleitung

b) Keep your hands away from rotating inser-
tion tools. The insertion tool may move over your
hand in the event of a kickback.
c) Keep your body away from the area where the
power tool may move in the event of a kick-
back. Kickbacks always move the power tool in
opposite direction to the movement of the grinding
disk at the spot where it blocks.
d) Corners, sharp edges, etc. must be processed
with special care. Make sure that the insertion
tool does not bounce back or get trapped on the
work piece. The rotating insertion tool tends to
jam in corners, at sharp edges or when it bounc-
es back. This may cause the loss of control or a
kickback.
Additional safety notes regarding grinding with
sandpaper- Special safety notes regarding grind-
ing with sandpaper
a) Do not use oversized abrasive sheets; always
observe the manufacturer's specifications for
abrasive sheet dimensions. Abrasive sheets
protruding the grinding plate may cause injury or
result in the blocking or tearing apart of the abra-
sive sheet or in kickbacks.
Additional safety notes
a) Connect a vacuum cleaner to the supplied adapter
before starting your operations.
b) Attention! Keep away grinding dust from open fire.
Dust may be explosive.
c) Always wear goggles and a dust mask when
grinding, in particular during overhead work and
when processing critical materials! When grinding
certain materials (e.g. lead paint, certain types
of wood and metal) harmful or noxious dust may
be generated. Touching or breathing in such dust
may imply risks for the operator or people in the
vicinity.
Notes regarding vibration and noise emissions
Reduce noise emissions and vibrations to a minimum!
1. Only use power tools which are free of defects.
2. Maintain and clean the power tool on a regular
basis.
3. Adjust your way of working to the power tool.
4. Do not overload your power tool.
5. Have your power tool inspected, if necessary.
6. Switch off the power tool when it is not in use.
Remaining risks
Even if you use this power tool in compliance with the
regulations, there are still remaining risks. The follow-
ing risks may occur due to the type and design of the
power tool:
a) Damage caused to your health resulting from
hand/arm vibrations if the power tool is used over
a Ionger period of time or if it is not properly used
and maintained.
b) lnjury and damage to property caused by flying off
insertion tools which are unexpectedly expelled
from the power tool due to sudden damage, wear
or incorrect insertion.
c) Burns and cuts if the insertion tools are touched
directly after use and/or with your bare hands.
Warning! This electric tool generates an electromag-
netic field during operation which may impair active or
passive medical implants under certain circumstanc-
es. ln order to reduce the risk of severe or Iethal inju-
ry, we recommend that persons with medical implants
consult their doctor and the manufacturer of the medi-
cal implant before using the power tool.

6. Technical Data

Nominal voltage:
Nominal frequency:
Power consumption:
Nominal speed (oscillation
rate) n:
Spindle size:
Abrasive paper diameter:
Protection class:
Weight:
Sound level
Sound pressure Ievel L
Sound power Ievel L .:
WA
Uncertainty K
Hand-arm vibration
When grinding with abra-
sive sheets a
h
Uncertainty K:
220-240 V~
50 Hz
710 W
800 - 1800 1/min
M14
215 mm
4,9 kg
.: 94,2 dB(A)
PA
105,2 dB(A)
3 dB(A)
5,848 m/s
1,5 m/s
GB | 27
II
2
2