Cleaning The Ring Switch; Led Replacement - Ecom Lite-Ex PL 10e Bedienungsanleitung

After inserting the new batteries (observe the correct
polarity) the body of the flashlight can be screwed back
on. Please make sure the flashlight has been screwed
together completely before switching it on again.
Battery replacement
• Only use type-tested batteries
(see Ex-Safety Manual, table in section 6)
• Always replace all batteries simultaneously.
• Pay attention to the correct polarity.
• Dispose of depleted batteries in an appropriate and
environmentally friendly manner!
• When changing the batteries examine the threads and
seals for cleanliness and signs of damage.

3.4 Cleaning the ring switch

A non-contacting ring switch is used to switch on the
Lite-Ex PL 10e (see description above). Dirt and moisture
do not impair the switching function. The ring switch
is easy to clean if excessive amounts of dirt and grime
have made it difficult to turn. Start by unscrewing the
lamp head. (See point 3.3 Battery replacement). The ring
switch can now be removed and cleaned. When it has
been cleaned replace the ring switch and rotate it until it
engages firmly in place (magnet must be positioned on
the shaft - P+F address side). The lamp head can then be
screwed back onto the flashlight.

3.5 LED replacement

The Lite-Ex PL 10e is equipped with a long-life LED bulb.
Under normal conditions it is not necessary to change the
LED. If, however, the torch is defective or the brightness
of the torch has diminished, it should be sent to ecom
instruments for inspection or repair. The LED housing
should not be opened!
6