Assembly Of The Lite-Ex Pl 10E; Getting Started; Battery Replacement - Ecom Lite-Ex PL 10e Bedienungsanleitung

3.1 Assembly of the Lite-Ex PL 10e

Lamp head
Disc
Fig. 1

3.2 Getting started

The supplied batteries must be inserted to begin with
(outside the Ex-area). In order to be able to use the
flashlight in the Ex-area it must be ensured that the lamp
head and the body of the flashlight are screwed together
tightly. The flashlight can then be switched on by lightly
rotating the yellow ring switch clockwise.

3.3 Battery replacement

The batteries should be replaced if the level of luminance
is no longer deemed to be satisfactory. It is advisable
to change all 3 batteries at the same time. Only the
appropriate, approved types of batteries may be used (see
Ex-Safety Manual, table with approved batteries).
To replace the batteries grasp the lamp head firmly, twist
the body of the flashlight (incl. ring switch) anti-clockwise
and then remove it. The batteries can then be removed
from the battery compartment and exchanged.
Thread-forming screw for
plastic 20 x 10 T6
Belt clip
Flashlight body
LED housing
Sealing ring 22.76 x 2
Ring switch
Sealing ring 22.8 x 1.5
5