Ahrend 500 Gebrauchsanweisung Seite 36

3
5
After delivery
Cabinets are delivered with pull-
out frames, trays and drawers
blocked. The anti-tilt bar has to be
pushed down so that they can be
pulled out for the first time - on the
right side only in the case of 80 cm
wide cabinets and on both sides on
120 cm wide cabinets.
English
4
Transport clamps may be removed
once the cabinet has been installed.
Interiors
Cabinets are usually supplied with a predetermined inte-
rior lay-out specifically ordered for the workstation.
Pull-out drawer
In a 33 cm deep pull-out drawer (fig. 3) you can use the
same accessories as in A6/A7 drawers in drawer
pedestals (see page 9).
Shelves for lateral suspension files
The shelves for suspension files have extra ridges under
the front and back edges from which you can hang lat-
eral suspension files (fig. 4). You can hang them at any
height in the cabinet you wish.
Suspension file frames
The cabinet is supplied with the suspension file frames
(fig. 5) mounted such that you can hang A4 suspension
files in them. You may, however, have them fitted at any
height you require in the cabinet. If a pull-out frame
slides forward on its own, it means that the cabinet is
not level and must be readjusted (see page 10).
Adjusting the shelves
Shelves can be placed at any height
in the cabinet. To adjust the height,
open the cabinet fully, lift the shelf
at an angle and pull it towards you
out of the cabinet.
Safety
When one suspension file frame is pulled out, you will
not be able to pull out any of the other frames. They are
blocked to prevent the cabinet from tipping over.
Two pull-out frames and drawers may be opened
at the same time. Be aware of the risk of tipping if the
drawers are heavily loaded.
When the position of pull-out frames and drawers
in the cabinet is changed, the locking pawls on the anti-
tilt bar will also have to be moved for safety reasons.
This has to be done by a specialist fitter.
Twist the shelf supports out of the
slots (1,2) and reposition them at
the height you require (3,4).
Make sure that they are at the same
height at the front and back and on
both sides. Use the round holes next
to the slots as points of reference.
Tilt the shelf at an angle again,
return it to the cabinet and place
it on the two supports.
35