General Power Tool Safety Warnings; Work Area Safety; Electrical Safety; Personal Safety - Parkside PMNF 1350 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

The vibration emission value specified was measured
according to a standardised testing method and may
vary depending on the method the power tool is
being used, and in exceptions be higher than the
specified value.
The vibration emission value specified can be used
to compare power tools.
The vibration emission value specified can also serve
as a preliminary assessment of the impact.
Try to keep the vibration loads as low as possible.
Measures to reduce the vibration load are, e.g. wea-
ring gloves and limiting the working time. Wherein all
states of operation must be included (e.g. times when
the power tool is switched off and times where the
power tool is switched on but running without load).
General power tool
safety warnings
warnings and all instructions. Fail-
ure to follow the warnings and instructions
may result in electric shock, fire and / or serious injury.
Save all warnings and instructions for
future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-op-
erated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
b) Do not operate power tools in explosive
atmospheres, such as in the presence
of flammable liquids, gases or dust.
Power tools create sparks which may ignite the
dust or fumes.
c) Keep children and bystanders away
while operating a power tool. Distractions
can cause you to lose control.
All manuals and user guides at all-guides.com
Introduction / General power tool safety warnings

2. Electrical safety

a) Power tool plugs must match the outlet.
b) Avoid body contact with earthed or
c) Do not expose power tools to rain or
d) Do not abuse the cord. Never use the
Read all safety e) When operating a power tool outdoors,
f) If operating a power tool in a damp

3. Personal safety

a) Stay alert, watch what you are doing
b) Use personal protective equipment.
Never modify the plug in any way. Do
not use any adapter plugs with earthed
(grounded) power tools. Unmodified plugs
and matching outlets will reduce risk of electric
shock.
grounded surfaces, such as pipes,
radiators, ranges and refrigerators.
There is an increased risk of electric shock if
your body is earthed or grounded.
wet conditions. Water entering a power tool
will increase the risk of electric shock.
cord for carrying, pulling or unplugging
the power tool. Keep cord away from
heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the risk
of electric shock.
use an extension cord suitable for out-
door use. Use of a cord suitable for outdoor
use reduces the risk of electric shock.
location is unavoidable, use a residual
current device (RCD) protected supply.
Use of an RCD reduces the risk of electric shock.
and use common sense when operat-
ing a power tool. Do not use a power
tool while you are tired or under the
influence of drugs, alcohol or medica-
tion. A moment of inattention while operating
power tools may result in serious personal injury.
Always wear eye protection. Protective
equipment such as dust mask, non-skid safety
shoes, hard hat, or hearing protection used for
appropriate conditions will reduce personal in-
juries.
GB 7