Troubleshooting - Amewi BuZZard V2 Bedienungsanleitung

To change the mode of the remote control from mode 2 to mode 1 and vice versa, push the left trim
button forward and switch on the remote control at the same time.
Problem
Connect the battery with helicopter, then the
signal light keeps flashing and without
response when operate.
The helicopter does not respond when the
battery is connected.
The throttle is pushed upwards but the
motor does not react, the indicator light on
the transmitter flashes.
The engine starts but the helicopter does not
take off.
The helicopter vibrates very strongly
The helicopter turns left when it takes off.
The helicopter is drifting in one direction.
The helicopter drifts off strongly and cannot
be corrected by the trim.
BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL BUZZARD V2
SWITCH MODE

TROUBLESHOOTING

Possible Cause
The helicopter without bind with the
transmitter.
Battery empty,
Battery is not connected correctly.
The battery is empty, the battery has no
connection.
The battery is empty, the main gear or rotor
shaft are loose.
Rotors are screwed too tightly.
Rotor shaft is bent.
The tail rotor is deformed.
The rear engine has too little power
The rear rotor is not fixed.
Rear engine is defective
The helicopter is too close to the ground.
Trim was not performed.
Servo defective
SOLUTION
Bind the transmitter again.
Check the battery voltage.
Charge the battery.
Plug in the battery.
Check the battery voltage.
Charge the battery.
Plug in the battery.
Charge the battery
Check the motor shaft and the main gear on
its fixed seat.
Loosen the screws on the rotor blades
slightly.
Replace the crooked wave.
Replace the rear rotor.
Check the rear engine and rear rotor on a
fixed seat.
Replace the rear engine or the rear rotor.
Bring the helicopter to a height of one meter
Run out the trim as described in the manual.
Replace defective servos.
28