Use Of The Appliance - Outwell KATLA CAMPING HEATER Bedienungsanleitung

UK: INSTRUCTION MANUAL

USE OF THE APPLIANCE

Connection:
• Make sure the oscillation switch is in the OFF (0) position, and that both controls (5) & (6) are in the OFF
[ - ] & [ 0 ] positions, then plug the heater into an appropriate electrical outlet and switch on power to the
outlet.
• Always use a separate socket that has no other high wattage appliances connected at the same time – do
not plug it into a power board or socket adaptor.
• Do not use an extension cord, unless it can handle a sustained load of at least 10A. Make sure an extension
cord on a reel is spooled out completely before use. Ensure the extension cord is not covered in any way.
Fan / heat operation
• The mode control (6) has four positions: "Off" [ 0 ], "fan only" [ fan symbol ], heat level 1 [ I ] and heat level 2 [ II ].
• Off: No fan, no heat
• Fan only: Fan running, no heat
• Heat level 1: Fan + heat (1000 W)
• Heat level 2: Fan + heat (1800 W)
Setting the temperature
• The temperature control (5) operates the thermostat, which you can set to maintain the room
temperature at the desired level.
• Turn the knob clockwise to the highest setting [ + ] until the room is comfortably warm.
• When the room temperature is comfortable, slowly rotate the knob anticlockwise (turn towards [ - ] ) until
the heater cycles off audibly and the control lamp (11.) turns off. The heater will now cycle on and off to
maintain the room temperature at this set level.
Oscillation
• The heater has an oscillation (swing)function of approximately 45°, which helps to provide uniform
heating or ventilation.
• The heater has an oscillation switch (10) located on the rear of the heater body (1)
- The switch has two positions: ON [ I ] and OFF [ 0 ].
- When switched ON [ I ] the heater will oscillate, regardless of the position of the mode control (6).
- The oscillation will however be switched on and off, as the thermostat (5) switches the heat on and off.
• To stop the swing while the appliance is oscillating, wait until the airflow is in the desired direction, then
switch the oscillation switch (10) to OFF [ 0 ].
CAUTION: Never attempt to adjust the swiveling mechanism manually, as it could damage the heater
Switching off
• When you no longer need the heater, turn the mode control (6) to the OFF [ 0 ] position and the
temperature control (5) to the minimum position [ - ].
• Unplug the heater from the power source and wait for it to cool down before packing it away.
Tilt protection (tip over switch):
The appliance is fitted with a tip over safety switch (7), which switches the heater off automatically if it is
tilted or tips over. This prevents hazards caused by overheating. Should this happen, place the heater upright
again, but take care as it may still be hot. The heater will turn on again automatically once it is back in an
upright position.
WARNING: Always place the appliance on a smooth, horizontal surface. Avoid carpets in order to prevent
failure of the safety switch.
Overheat protection:
This heater is equipped with an automatic reset temperature control (overheat protection), which switches
the heater off automatically in the event of abnormal overheating. While this feature provides additional
safety in case of overheating, first and foremost you should make sure to eliminate all potential reasons that
can lead to overheating and create a fire risk.
4