Maintenance Cleaning; Error Messages - GREENLIFE GAP X100 Anleitung

MAINTENANCE CLEANING

MAINTENANCE CLEANING
Icing of the pump must be avoided in any case. Remove the pump from the medium
at temperatures around zero degrees and drain the pump. Store the pump in a frost-
proof place. For cleaning purposes, the pump must be current-free.

ERROR MESSAGES

In most cases, you can easily fix the problems. Please note the following notes in the
table. This will save you a lot of work and possible expenses.
error
Pump does not start
Pump switches on
and off
Too small flow rate. No
or little flow of water
The pump doesn't
switch off
Submersible pressure pump
reason
1. interruption of the power
supply - defective power cable
or plug.
2. check valve blocked in open
position
3. not enough water
Leakage in the consumer line
1. insufficient water supply, not
up to impeller height
2. kink in the discharge line
3. dirty water or particles in the
water reduce the water
flow
4. blockage of the inlet
The non-return valve in
the pump is jammed/clogged or
contaminated
1 6
GAP X100 I X120
error fixing
1. monitory of power supply
inspection of safety devices
2. maintenance by qualified
personnel is recommended
3. restore the water level
Check the consumer line for
leaks, reseal if necessary. Clean
the pump.
1. increase water supply
2. check and repair hose/pipe
3. clean inlet and replace
damaged parts
4. clean the inlet
Maintenance by qualified
personnel is recommended