Maintenance Cleaning; Error Messages - GREENLIFE GAP X100 Einbauanleitung

Installation instructions
GreenLife Clarified water pressure pump

Maintenance Cleaning

Icing of the pump must be avoided in any case. Remove the pump from the medium
at temperatures around zero degrees and drain the pump. Store the pump in a frost-
proof place. For cleaning purposes, the pump must be current-free.

Error messages

In most cases, you can easily fix the problems. Please note the following notes in the
table. This will save you a lot of work and possible expenses.
Error reason
Pump does 1. interruption of the power
not start supply - defective power cable
or plug.
2. check valve blocked in open
position.
3. too little water
Pump Leakage in the consumer line.
switches on
and off.
Too small 1. Unzureichende
Flow rate. Wasserversorgung, nicht bis
No or little Laufradhöhe.
flow of water. 2. Knick in der Druckleitung.
3. Schmutzwasser oder
Partikel im Abwasser
reduzieren den Wasserfluss.
4. Verstopfung des Einlasses.
The pump The non-return valve in
Doesn't the pump is jammed/clogged
switch off. or contaminated
No liability is assumed for printing errors Status: 2020.01.28
Telefon: +49 (0) 385 7733 775
E-Mail: service@greenlife.info
Bug fixing
1. monitoring of power supply /
inspection of safety devices.
2. maintenance
personnel is recommended.
3. restore the water level.
Check the consumer line for leaks,
reseal if necessary. Clean the
pump.
1. insufficient water supply, not
until
Wheel height.
2. kink in the discharge line.
3. dirty water or particles in the
waste water reduce the water flow.
4. clogging of the inlet.
Maintenance by qualified personnel
is recommended.
7
by qualified
www.greenlife.de
Stand: 2020.01.28
Subject to technical changes