ASSEMBLY
1
COMMISSIONING
Please check the following points before connecting the pump to the mains:
1. Check all pipes and hoses for leaks
2. Check that the maximum immersion depth is not exceeded (12 m)
3. Is the pump firmly mounted?
4. Do all electrical connections comply with the safety instructions on the
technical name plate?
5. Is contamination in the water excluded to prevent clogging?
6. Is a consumer open?
ASSEMBLY & COMMISSIONING
2
1 5
HOW TO REPLACE THE
PUMP FOOT
1. Turn the pump upside down,
loosen the 3 screws on the pump
and pull it off.
2. To install the pump base, align
the holes between the base and
the pump and then screw the
base tight.
Change, clean and maintain the
pump base only when the power
is off.