Installation instructions
GreenLife Clarified water pressure pump
Assembly
Assembly pump foot:
2
1
Commissioning
Please check the following points before connecting the pump to the mains:
1. check all pipes and hoses for leaks
2. check that the maximum immersion depth is not exceeded (12 m)
3. is the pump firmly mounted?
4. do all electrical connections comply with the safety instructions on the
technical name plate?
5. is contamination in the water excluded to prevent clogging?
6. is a consumer open?
No liability is assumed for printing errors Status: 2020.01.28
Telefon: +49 (0) 385 7733 775
E-Mail:
service@greenlife.info
Replace pump foot:
(1.) Turn the pump upside
down, loosen the 3 screws on
the pump base and pull it off.
(2.) To install the pump base,
align the holes between the
base and the pump and then
screw the base tight.
Change, clean and maintain
the pump base only when the
power is off!
6
www.greenlife.de
Stand: 2020.01.28
Subject to technical changes