Working Position; Assembling / Dismantling - CombiSteel 7455.0170 Gebrauchsanweisung

All manuals and user guides at all-guides.com

WORKING POSITION

Blender function: For greater control, we recommend that you hold the bender by the handle and the bottom
of the motor unit. Furthermore, we recommend that you tilt the blender at a slight angle to prevent the bell
from touching the bottom of the container. Always make sure that the bell is sufficiently immersed to avoid
splashing and that the air vents of the motor unit do not come into contact with any liquids. For optimal efficiency,
two thirds of the stick should be immersed in the preparation.
Whisk function: You can also hold the appliance by the handle with one hand, leaving the other hand free to
hold the bowl, if necessary. While you process the preparation, we recommend that you move the whisk around
in the bowl, in order to ensure that the mixture is completely homogeneous. We strongly advise you to keep the
whisk from touching the sides of the bowl. For Maximum efficiency, at least one-fifth of the whisk length should
be immersed. But never immerse the whisk holder into the preparation.

ASSEMBLING / DISMANTLING

The assembly / disassembly operations of every part of the appliance are performed with the appliance
stopped and with the plug disconnected from the socket.
Assembly Model 7455.0170:
1. Align and insert the coupling (5) of the stick (3) or whisk (6) in the clutch (2) of the machine body (1).
2. Screw the stick (3) or whisk (3) up to fasten it firmly to the machine body (1).
Assembly Model 7455.0175, 7455.0180, 7455.0185:
1. Align and insert the coupling (5) of stick (3) or whisk (4) in the clutch (2) of the machine body (1). Be sure the
concave side of coupling catches into the convex of the clutch.
2. Screw the nut (6) up to fasten them firmly to the machine body (1).
7
www.combisteel.com