How To Use The Vacuum Cleaner; Cleaning And Maintenance - Eldom OS 2000B Bedienungsanleitung

HOW TO USE THE VACUUM CLEANER

All manuals and user guides at all-guides.com
The vacuum cleaner is designed for cleaning hard surfaces made of wood, plastic or tiles, as well as soft
surfaces, such as carpet, rugs, upholstery etc.
Before first use, please assembly the required parts of the vacuum cleaner:
- check if the included paper bag (15) and filters (16) and (17) are installed.
In order to do this, open the cover (5) by pressing the button (6). When checking is complete, close the cover.
- insert one end of the flexible hose (8) into the hole in the cover (5),
- connect the telescopic tube (10) with the flexible hose (8) and install the attachment you want to use (11,
12, 13, 14),
- unwind the power cord and plug the vacuum cleaner,
- in order to start the vacuum cleaner, press the button (1). While cleaning, you can adjust suction force using
the electronic controller (2) or regulator (9),
- press button (1) to turn the vacuum cleaner OFF,
- wind the cord by pressing and holding the button (3),
Do not use the device without filters (16,17) or bag (15).

CLEANING AND MAINTENANCE

The cover, accessories and the power cord can be cleaned with a soft, damp cloth and a bit of dishwashing
detergent. Do not put the device in water. Do not use any corrosive cleaning agents as they could damage
the surface of the vacuum cleaner.
In order to ensure proper operation of the device, clean and change filters and replace bags regularly.
In order to change the bag (15), follow the steps below:
- unplug the device from the mains,
- take out the hose (8),
- open the cover (5),
- remove the bag (15) from the holder,
- install a new bag,
Filters
The vacuum cleaner is equipped with two filters:
- the internal inlet filter (17) protects the motor against damage.
The filter can be accessed by opening the cover (5) and removing the dust bag (15),
- the outlet filter (16) serves as a protection against air contamination in cleaned rooms.
The outlet filter can also be accessed by opening the cover (5).
The filter frame (17) can be cleaned with water.
USEFUL TIPS
- the vacuum cleaner can be stored in either horizontal or vertical position
- in the base of the vacuum cleaner and above the outlet filter, there are place (pic. 2) for fastening the suction
hose, (on the large brush „11" there is a suitable catch)
- during storage, make sure that the suction hose is not excessively bent or squeezed
- while cleaning upholstery, small rugs or delicate fabric, we recommend decreasing the suction force using the
regulator (9)
- use the crevice nozzle for cleaning places that are difficult to access (corners, crevices etc.) (13).
- the bag must be replaced when the suction force of the vacuum cleaner decreases significantly or when the
indicator (4) indicates full bag
- carry the vacuum cleaner using the handle (7) only
PIC. 2
6