Troubleshooting - Philips AZ-2030 Bedienungsanleitung

All manuals and user guides at all-guides.com

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING:
Do not open the set as there is a risk of electric shock. Under no
circumstances should you try to repair the set yourself, as this would
invalidate the guarantee.
PROBLEM
– POSSIBLE CAUSE
• REMEDY
No sound/power
– VOLUME not adjusted
• Adjust the VOLUME
– Headphones connected
• Disconnect headphones
– Mains lead not securely connected
• Connect the AC mains lead properly
– Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
Severe radio hum or noise
– Electrical interference: set too close to TV,
VCR or computer
• Increase the distance
Poor radio reception
– Weak radio signal
• FM: Direct the FM telescopic aerial for
optimum reception
indication
– No CD inserted
• Insert a CD
– CD badly scratched or dirty
• Replace/ clean CD, see
– Laser lens steamed up
• Wait until lens has cleared
This product complies with the radio interference requirements of the European Union.
The type plate is located on the bottom of the set.
14
MAINTENANCE
indication
– CD-R(W) is blank or the disc is not finalised
• Use a finalised CD-R(W)
– CD badly scratched or dirty
• Replace/ clean CD, see
The CD skips tracks
– CD is damaged or dirty
• Replace or clean the CD
– SHUFFLE or PROGRAM is active
• Switch off SHUFFLE/ PROGRAM
Poor cassette sound quality
– Dust and dirt on the heads, etc.
• Clean deck parts etc., see
– Use of incompatible cassette types (METAL
or CHROME).
• Only use NORMAL (IEC I) for recording.
Recording does not work
– Cassette tab(s) may be broken
• Apply a piece of adhesive tape over the
missing tab space.
Remote control does not function properly
– Batteries dead/ incorrectly inserted
• Insert (fresh) batteries correctly
– Distance/ angle between the set too large
• Reduce the distance/ angle
– Remote sensor obstructed by object, sticker
etc.
• Remove obstruction/ make sure right hand
side of cassette door is free from obstruction
MAINTENANCE
MAINTENANCE