Daily Maintenance; Clean The Dust Box; Clean The Rolling Brush - TCL Sweeva 6000 Benutzerhandbuch

EN

Daily Maintenance

Clean the dust box

Empty the dust box, put the dust box close to the trash can,
①
and tap the dust box gently to knock off the excess dirt.
Disassemble the removed filter assembly, take out the
②
high-performance filter, and clean the filter with the
supplied cleaning brush.
The dust box and filter assembly can be thoroughly rinsed
③
with water as needed. (Note: The filter cannot be cleaned
with hot water or detergent.)
After cleaning, the dust box and filter assembly must be
④
thoroughly air-dried. (Note: Repeated washing will destroy
the material of the high-performance filter and make it
ineffective. Please clean it with caution.)
Reassemble the air-dried dust box and filter assembly, and
⑤
put it back into the robot vacuum.
If the wet dust box and filter assembly are put back into
*
the robot vacuum, it may cause damage to the main
machine or fan.
Clean the dust box

Clean the rolling brush

As shown in the figure below, press the buckle to take out
①
the protective cover, and take out the rolling brush
upwards.
Clean the rolling brush with a cleaning tool, and the blade
②
can cut off the hair entangled on the rolling brush.
Remove the spool at one end of the rolling brush and clean
③
away the hair entangled on it.
After cleaning, put the rolling brush back and make sure it
④
is installed in place.
2 2