Factory Setting - VOLTCRAFT ETC 902 Bedienungsanleitung

Table with parameters
Parameter code Description
Parameter Menu CP
diF Temperature step width
HSE Set maximum temperature
LSE Set minimum temperature
HC Control mode (H = heat; C = cool)
If the temperature sensor fails, the compressor is shifted to the cycle
mode:
Ont On t: Runtime for the switched-on phase
OF t: Runtime for the switched-off phase of the cycle.
Ont=0;OFt=1: Compressor remains off.
OFt Ont=1;OFt=0: Compressor is permanently on.
Ont≠0;Ont≠0: Compressor runs in the cycle
with the times for the switched-on and -off phases as described above.
dOn Delay time until the compressor starts
dOF Time interval between the
dbi The time interval between two consecutive comp. start processes
OdO Time delay of the output after the device switches on
Parameter Menu diS
LOC Button lock (n = buttons not blocked, y = buttons locked)
It is possible to program the parameters further
PA1 User password
ndt Display the decimal point: y = yes; n = no
CA1 Calibrate temperature
dro Temperature unit (0 = °C, 1 = °F)
Parameter Menu CnF
H00 Selection of the sensor type (0 = PTC, 1 = NTC)
rEL Device version
tAb Parameter overview
The target value [SEt] should always be between the parameters [LSE] (lowest target value to be set) and [HSE] (highest target value to be set). For example, if [HSE] is set to 10, the
target value cannot be set higher.
All manuals and user guides at all-guides.com
Value range
"1 - 30"
"LSE - 99"
"-55 - HSE"
"H/C"
On t: Runtime for the switched-on phase of the cycle. 0
"0-250"
"0-250"
"0-250"
"0-250"
"0-250"
"n/Y"
"0-250"
"n/Y"
"-12-12"
"0/1"
"0/1"
"/"
"/"

Factory setting

Unit
2 °C/°F
99 °C/°F
-55 °C/°F
H /
Minutes
1 Minutes
0 Seconds
0 Minutes
0 Minutes
0 Minutes
n /
0 /
n /
0 °C/°F
1 /
1 /
/ /
/ /