Assembling The Microscope; Power Supply; Adjusting The Lighting - Bresser DST-1028 Bedienungsanleitung

9 Assembling the microscope

This microscope is designed for operation with a Windows PC.
For the assembly proceed as follows:
1. Screw the running rail with the preassembled microscope holder into the holding thread. Make
sure that the holder is facing forward as shown.
2. NOTICE! For higher observation objects, the supplied extension piece can first be screwed
into the mounting thread. The rail is then screwed into the extension piece. This will increase
the working height significantly.
3. Loosen the fixing screw on the holder and unscrew it slightly so that it does not block the retaining
ring.
4. Insert the microscope head into the holder and hand-tighten the fixing screw.

10 Power supply

Plug the USB-A connector of the USB cable into a free USB port of the PC. The power is supplied
through the computer after it has been switched on. The LED ring lighting will light up.
11 Connecting to a PC
Use of this digital microscope requires a connection via USB to a PC running the Windows 10 operat-
ing system. Follow the steps below for proper connection:
1. Download and install the CamLabLite* software on the PC.
2. Mount the digital camera as described.
3. Insert the USB-A plug of the USB connection cable into a free USB port of the PC. If the connec-
tion is successful, the LED lights up. The digital microscope is ready for use.
4. The CamLabLite* software can be used to view and save images from the digital microscope. Fur-
thermore, various image optimizations can also be made. Please also read the separate software
instructions.
*Information about downloading the software and the software instructions can be found on page 2 of
this manual.

12 Adjusting the lighting

The digital microscope is equipped with a LED ring lighting for optimal object illumination and can be
dimmed continuously.
1. Connect the digital microscope to the PC.
2. Once the LED lighting is on, the brightness can be adjusted continuously by turning the dimmer
with on the USB cable.
13 Adjusting the height of the head
Depending on the size of the observation object or when changing the magnification setting, the posi-
tion of the microscope head must be adjusted in height. To do this, proceed as follows.
1. Hold the microscope head and loosen the locking screw for the holder.
2. Turn the height adjustment wheel to move the microscope head up or down in the holder.
3. Hand-tighten the locking screw when the desired height position is reached.
NOTICE! Especially when changing the zoom range, it may be necessary to additionally change
the position of the digital microscope in the holder. (see also "Focusing the object")
7 / 20