Kayoba 007637 Bedienungsanleitung Seite 40

EN
2. Place the hood over the fasteners (28)
for the handle (5), so that they are easily
accessible.
3. Fasten the back, bottom edge of the hood
with the Velcro fastener.
4. Fasten the sides of the hood with the
Velcro fasteners.
5. Pull the hood forwards so that it covers
the bike trailer.
6. Follow the instructions in the reverse order
to remove the hood.
FIG. 6
HANDLE
1. Put the ends of the handle (5) in the
fasteners (28).
2. Press down the handle until the catches
click in place.
3. To remove the handle, press in the catches
and pull the handle out of the fasteners.
FIG. 7
WHEELS
1. Put the bike trailer on its side.
2. Put the axle (10) for one of the wheels
(11) in the axle bracket (4).
3. Press down the wheel axle until the catch
clicks in place.
4. Turn the bike trailer over and fit the other
wheel in the same way.
5. To remove a wheel, press the catch (24)
and pull the wheel off the axle bracket.
6. Repeat for the other wheel.
FIG. 8
FLAG
1. Fit both parts of the flag stick (14)
together.
2. Put the flag stick in the fastener (17).
40
3. Remove the flag by pulling the flag stick
out of the fastener.
4. Pull apart the two parts of the flag stick.
FIG. 9
EXTENSION / WITHDRAWAL
OF TOW BAR
1. Put the bike trailer on its left side. Release
the retaining clip for the pin (22) and pull
the pin out of the hole.
2. Release the safety strap (21) on the tow
bar (18).
3. Pull the tow bar forwards.
4. Put in the pin and secure with the
retaining clip.
5. To withdraw the tow bar, release the
retaining clip for the pin and pull the pin
out of the hole.
FIG. 10
6. Push the tow bar under the bike trailer.
7. Fasten the safety strap round the axle.
8. Put in the pin and secure with the
retaining clip.
FIG. 11
COUPLING / UNCOUPLING
Tow bar fastener on bike
1. Undo the screw on the back wheel axle
with a suitable tool (sold separately).
2. Put the tow bar fastener (13) on the back
wheel axle.
3. Tighten the screw.
FIG. 12