Activating The Encryption - Werock BC200 Bedienungsanleitung

Hint
WLAN streaming and pre-recording cannot be combined and can lead to undesired behavior.
Hint
Do not use the 1296P configuration with a video length of 30 minutes. This could cause problems.
Hint
In any case, check whether all settings have been correctly adopted before you use the device again
in operation. Due to the limited processor power, memory settings that have already been set can also
be lost when parameters are changed. If necessary, these must then be set again. This is not a
malfunction, but due to the extremely low power consumption.

Activating the encryption

The WEROCK Impakt BC200 Body Camera uses a multi-layer encryption method. The internal memory is
encrypted using a password with AES256 algorithm. In addition, the video data can be encrypted with
RSA2048. To activate the additional encryption, proceed as follows:
You need an RSA key pair, the so-called "Public Key" and the "Private Key". An exemplary key pair is
stored in the Impact Tools folder "key". However, we recommend that you create your own key pair. Replace
the key files with your own. Make sure that the file names are the same.
1. Activate the encryption in the Camera Tool software by setting "RSA-Encryption" to on. Confirm the
change by clicking on "Apply
BC200 User Manual
65 / 82