Camera Settings - Werock BC200 Bedienungsanleitung

6. Press and hold the photo button to activate the WLAN function.
-> The white LED starts to light up.
It can now take 10-20 seconds until the product has logged on to the router and an IP address has been
assigned.
7. Re-connect the product to the computer using a docking station or the USB port.
8. Start the "WiFi Configuration Tool" and click on Connect. If the connection is successful, the message
"Found a device" appears in the lower area
9. Click on "Get IP" to get the current IP address.
=> You can now access the camera's RTSP stream via the displayed IP address.

Camera Settings

The software is configured via the "Camera Tool". The software allows the configuration of the following
functions and parameters:
·
Change the device password
·
Changing the Device ID
·
Change User ID / Police ID
·
WLAN SSID and password
·
Device time
·
Video resolution and video quality
·
Post- and Pre-Recording Mode
·
Audio settings for pre-recording mode
·
Infrared sensors
·
Loudspeaker volume
·
Photo resolution
·
Activated WLAN and GPS function at startup
·
Length of the video file
·
Notification of admission
·
Motion detection
·
RSA Encryption
·
Front LED
·
Loop recording
·
Stealth mode
·
Behavior after device activation
·
Enabling the camera as a mass storage medium
·
Preparation for firmware update
BC200 User Manual
63 / 82