Inhaltsverzeichnis
Werbung
REPLACING THE BATTERY
The detector works using a 9V Alkaline battery.
The battery will last approximately 5 years in normal conditions, provided the instructions
and recommendations in this guide are followed.
The detector has a low-battery indicator and emits a beep at an interval of 40-50 seconds
for at least 30 days.
As soon as you hear this signal, replace the battery with one of the 9V batteries below.
(models available in most shops)
ATTENTION
The batteries listed below will ensure proper functioning of the detector:
Type Alkaline: Raymax 6LR61, Duracell MN1604
The battery must be connected correctly to the pressure connector while bearing in mind the
polarity of the batteries.
Once the battery is inserted, press the button to test it.
The design of this detector means it is impossible to fix it in place if there is no battery inside.
Be sure to check that the battery is properly installed, then it will be easy to attach it to the base.
FALSE ALARMS
The smoke detector is designed to minimize unnecessary alarms.
Smoking will usually not trigger the alarm, unless you blow directly towards the detector.
Cooking fumes can set it off if the detector is too close to the stove-top, and if a large
amount of smoke is given off by the hot-plates or the grill.
ATTENTION
If you are ever unsure as to the cause of an alarm, always evacuate the
building and make sure the alarm has not been triggered by an actual fire.
If the alarm in the detector goes off, first of all check if it is because of a fire.
If there is a fire, evacuate and call the emergency services.
If no fire can be found, check if one of the possible causes mentioned earlier is responsible for the
false alarm.
EN
5
Version: 5.0
19.05.2016
Werbung
Inhaltsverzeichnis
