BOMANN GB 341 Bedienungsanleitung, Garantie Seite 17

- Place the appliance so that the appliance door
can open without being impeded.
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to the "EU Product Data Sheet" or to the rating la-
bel located in the interior or on the appliance rear.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the installation: Avoid the installation: Avoid the installation: Avoid the installation:
- near heaters, next to a stove, direct sunlight or
any other heat sources;
- at locations with high humidity (e.g. outdoors,
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
- near volatile or flammable materials (e.g. gas,
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
- Do not expose the appliance any weather.
Electrical connection Electrical connection
Electrical connection Electrical connection
WARNING: WARNING:
WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock shock!
shock shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
• Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
• Connect the mains cable to a properly installed
and earthed wall outlet.
All manuals and user guides at all-guides.com
• If the plug after installation is not accessible, a
Reverse the door opening Reverse the door opening
Reverse the door opening Reverse the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
When replacing the door stop, the appliance must be
disconnected from the power supply first.
You possibly need:
er as well as a thin-blade screwdriver.
• Remove the blind cap (1) and the hinge cover (2).
• Loosen the screws (3), remove the door hinge (4)
• Move the blind plug (5) of the appliance door to
electric
electric electric
• Tilt the appliance slightly backwards and block it
• Move and fasten the door hinge (6) incl. base with
• Put the appliance back in the upright position. Put
• Replace the hinge cover (2) and move the blind
17
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
WARNING: WARNING: WARNING: WARNING:
NOTE: : : : NOTE
NOTE NOTE
screw wrench, Phillips screwdriv-
and lift the appliance door.
the opposite side. Set the door aside safely.
in this position. Dismount the door hinge (6) with
its base by loosening the screws (7). Unscrew the
separate foot (8).
the screws (7). Screw in the separate foot (8) ac-
cordingly.
on the appliance door and fix it in the intended
position. Move and fasten the door hinge (4) with
the screws (3).
cap (1) into the exposed hole.