Please Note; Connection & Power Supply - iBricks Solutions airdot pro Sicherheits- Und Montagehinweise

PLEASE NOTE

To achieve good measurement results, the follo-
wing must be observed when installing/setting up
the airdot pro:
• Do not place the airdot pro directly in areas
subject to a lot of human exhalation. The air-
dot pro should, where possible, be placed at
least 2 m away from any permanent occu-
pancy areas (workplace, sitting area).
• The airdot pro should not be placed next to
a ventilation point (window). The airdot pro
should ideally be placed on the opposite side
of the room to the window or in a space with
no windows.
• Do not position the airdot pro in the air cur-
rent path of ventilation systems.
• Make sure that the air around the airdot pro
can circulate properly. Do not position it in a
niche and never cover it with other objects.
• The ideal place for the airdot pro is on the
wall opposite the ventilation area at a height
of 1.5 m.
CONNECTION & POWER SUPPLY
30 31
Connect the airdot pro to any USB port using the
USB plug. This could be:
• A USB plug-in unit (phone charger)
• A portable USB power supply (power bank)
• A laptop or computer
• An in-wall USB port or a socket with USB
connection
ENGLISH
You can purchase a suitable 230 V USB plug-in
unit as an accessory from iBricks. However, any
standard power supply/charger with a USB-A
connection will work.
POWER SUPPLY
As soon as you connect the airdot pro to a power
supply, a short beep will sound, and 3 symbols and
the indicator bar will light up white shortly after.
This means that the device has tested itself and
is ready for use.
Should one of the symbols or the bar light up pink,
this means there is an error. If this occurs, consult
the operating instructions.
After a few seconds, the airdot pro will automati-
cally switch to the normal operating mode.