Setup & Installation; Setup As A Table-Top Device; Wall Installation With Adhesive Dot; Fixed Installation - iBricks Solutions airdot pro Sicherheits- Und Montagehinweise

SETUP & INSTALLATION
The iBricks airdot pro can be set up and installed in
three different ways:

SETUP AS A TABLE-TOP DEVICE

You can operate the airdot pro as a table-top de-
vice. To do so, fasten the included stands to the
rear side of the housing.

WALL INSTALLATION WITH ADHESIVE DOT

You can stick the included adhesive dot to the rear
side of the housing and use it to adhere the air-
dot pro to a wall or a piece of furniture. The device
should ideally be installed at a height of approx.
1.5 m.
SETUP & INSTALLATION
28 29

FIXED INSTALLATION

The airdot pro can also be permanently installed
on the wall. A socket is required for this. A 5 V pow-
er supply (available from iBricks as an accessory)
is integrated in the socket and connected to the
airdot pro.
ENGLISH
CAUTION:
You need to open the airdot pro housing to
connect the power supply and fit the fastening
screws. This installation method must be per-
formed by a specialist with the corresponding
knowledge of the applicable specifications (an
electrician)..