Inhaltsverzeichnis
Werbung
Step 3
Move the standoff based on the
module type and length.
The standoff is placed at the nut
A
E
D
C
B
location D by default. Skip Step 3 and
4 and go straight to Step 5 if you are
going to use the default nut.
Otherwise, release the standoff by
hand.
Step 4
Peel off the yellow protective film on
the nut to be used. Hand tighten the
E
D
C
B
A
standoff into the desired nut location
on the motherboard.
Step 5
Gently insert the M.2 (NGFF) SSD
module into the M.2 slot. Please
be aware that the M.2 (NGFF) SSD
module only fits in one orientation.
Step 6
Tighten the screw with a screwdriver
to secure the module into place.
Please do not overtighten the screw as
this might damage the module.
E
D
NUT2
NUT1
36
Werbung
Inhaltsverzeichnis
