Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATING
Use the correct product for the correct vehicle. The correct product will do the job better and safer at
the rate for which it was designed. Do not modify this product or use it for a purpose for which it is not
intended. Check for misalignment or binding of moving parts, breakage of parts and any other
condition that may affect the product's operation. If damaged, have the product repaired before use.
Use the product and accessories etc., in accordance with these instructions and in the manner
intended for the particular type of product, taking into account the working conditions and the work to
be performed. Use of the product for operations different from those intended could result in a
hazardous situation.
1
T-Handle (L/R)
2
Reset spindle (L/R)
3
Counterholding sleeve (L/R)
4
Brake caliper
5
Counterholding plate (1)
6
Reset adaptor (0/2/3/4/6/7/8/9/A/E/K/M/N)
7
Brake caliper holder
1. Move the T-handle of the reset spindle to the side and guide the counter plate over the reset
spindle until it rests on its end. Attach the reset adapter to the two pins on the bottom of the reset
spindle (it is held in place by a magnet).
2. Raise the vehicle and secure vehicle with jack stands and wheel chocks.
3. Remove wheel, brake caliper and the brake pads.
4. Service the brake caliper as recommended by the manufacturer.
5. Use the tool to push back the brake piston into the brake caliper.
6. Install the brake pads, brake caliper and wheel.
7. Clean the tools and store them in an inaccessible place for children.
ATTENTION
Test the brake system thoroughly before driving the car.
CARE / MAINTENANCE
Damaged products can fail, causing personal injury. Do not use a damaged product.
Before each use, inspect the general condition of the product. Check for misalignment or binding of
moving parts, cracked or broken parts, and any other condition that may affect its safe operation.
After use, clean external surfaces of the product with clean, moist cloth.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
6
e
s
s
a r t S
h
c
s
m
e
R
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
L
d . l h
a t s
w
s
@
o f n i
: l i
Werbung
Inhaltsverzeichnis
