Troubleshooting - Meec Tools 014168 Bedienungsanleitung

EN

TROUBLESHOOTING

Problem
No material comes
out through the
nozzle.
Material drips from
the nozzle.
The material is not
shredded properly.
32
Cause
The nozzle is blocked.
The suction hose is blocked.
The flow of material is set too low.
The suction hose has come loose.
The pressure in the container is too
low.
The material is too thick.
The nozzle is loose.
The nozzle is worn.
Material has accumulated in the air
nozzle, nozzle or paint needle.
The material is too thick.
The flow of material is set too high.
The nozzle is blocked.
The air filter is very dirty.
The pressure in the container is too
low.
Action
Clean.
Clean.
Increase the flow of material (+).
Fix the hose in place.
Screw the container on properly.
Thin the material.
Tighten.
Replace nozzle.
Clean.
Thin the material.
Reduce the flow of material (-).
Clean.
Replace.
Screw the container on properly.