Spraying Technique; Maintenance - Meec Tools 014168 Bedienungsanleitung

ADJUSTING THE FLOW OF MATERIAL
Adjust the flow with the knob on the trigger
catch.
- down = reduced flow of material
+ up = increased flow of material
FIG. 7

SPRAYING TECHNIQUE

• The surface to be painted must be free
from dust, dirt and grease.
• Mask areas that are not to be painted.
• Mask threads etc. on the object to be
painted.
• Test on cardboard first, or something else.
Start spraying outside the area to be
painted and avoid interruptions in this
area.
– Correct (A). Hold the spray gun at a
steady distance (10–30 cm) from the
object to be sprayed.
– Wrong (B). Uneven coating of
material or excessive spray mist.
FIG. 8
• Handle the spray gun with a smooth
action to obtain a uniform surface finish.
• Clean the nozzle and air nozzle with a
suitable solvent if they get clogged.
SHORT PAUSE
• Switch off the product.
• Put the spray gun in the holder on the
compressor unit.

MAINTENANCE

SWITCHING OFF AND CLEANING
Proper maintenance and regular cleaning are
essential for the product to work properly.
The warranty does not cover problems
resulting from inadequate cleaning.
1. Switch off the product. Press the trigger
catch so that the material in the spray gun
runs back into the container.
2. Unscrew the container and pour residual
material back into the original container.
3. Clean the container and suction hose with
a brush.
4. Pour solvent or water into the container
and replace it on the spray gun. Do not
use solvent that has a flash point lass than
21°C.
5. Start the product and spray the solvent
into a container or on a rag.
6. Repeat until only clean solvent comes out.
7. Switch off the product.
8. Completely empty the container.
Make sure that the seal is clean and
undamaged.
9. Press the catch, pull off the front part
of spray gun and clean it well. Press the
button and pull out.
FIG. 9
10. Clean the spray gun and container with a
cloth moistened with solvent or water.
11. Unscrew the lock ring and remove the air
nozzle and nozzle. Clean with solvent and
a brush.
IMPORTANT:
Never clean the nozzle and air holes on the
spray gun with sharp metal objects.
REPLACING THE AIR FILTER
Replace the air filter when necessary. Release
the cover on the compressor unit and put the
new air filter in the cover. Press the cover in
place again.
FIG. 10
WARNING!
Never run the product without an air filter –
risk of material damage when adjusting the
air flow.
EN
31