Herunterladen Inhalt Inhalt Diese Seite drucken

Installation And Operating Instructions; Checks Before Installation; Location - Hoshizaki HNC-120BE-L-BLH Bedienungsanleitung

Schauvitrine
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 24
ENGLISH
II. INSTALLATION AND OPERATING INSTRUCTIONS

1. CHECKS BEFORE INSTALLATION

* Visually inspect the exterior of the shipping container, and any severe damage noted should be reported to the carrier.
Remove shipping carton, evaporator spacer, tape(s) and packing. If packing material is left in the showcase, it will not
work properly.
Remove shipping tape holding the door.
* Remove the package containing accessories.
* See the nameplate on the rear of the showcase, and check that your voltage supplied corresponds with the voltage
specified on the nameplate.

2. LOCATION

This showcase is not intended for outdoor use.
Normal operating ambient temperature should be within 10°C to 30°C. Operation of the showcase, for extended
periods, outside of these normal temperature range may affect cooling performance.
For best operating results:
* The showcase should not be located next to ovens, grills or other high heat producing equipment.
* The location should provide a firm foundation for the equipment across its entire bottom surface. Any unevenness or the
insertion of packing resulting in only partial contact could result in the case becoming damaged or deformed causing a
failure. The showcase should always be level from side to side and back to front.
If the foundation is not firm enough, it may warp and cause some space between its center and the showcase bottom. In
this case, provide a support to keep the foundation level.
* Avoid a site where dripping is not allowed.
* Do not expose the showcase to direct sunlight or higher temperatures to prevent damage to the plastic housing.
* Allow at least 15 cm clearance between the condenser air inlet/outlet and the wall or other equipment for proper air
circulation. The rear of the showcase should have enough space for smooth operation of the power switch and for easy
access to the louver and air filter. Open space is required at the top of the showcase.
NOTICE
IMPORTANT
WARNING
IMPORTANT
No good
Good
No good
Good
Support
4

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis