Frequently Asked Questions (Faq) - AgfaPhoto POWERCUBE 300Pro Bedienungsanleitung

10. FREQUENTLY ASKED QUESTIONS (FAQ)

1. What type of battery is in my AgfaPhoto POWERCUBE 300Pro?
AgfaPhoto POWERCUBE 300Pro contains a 278Wh lithium ion battery pack. Lithium ion batteries are
much smaller and lighter than normal lead-acid batteries and also can be cycled many more times. It
has no memory effect and is therefore very durable. Nevertheless, we recommend that you charge the
device in a working temperature range of 10~30°C in order to achieve the optimum charging capacity.
2. How do I know if my AgfaPhoto POWERCUBE 300Pro is charged?
To check the charge level of your AgfaPhoto POWERCUBE 300Pro, refer to the battery indicator. The
number of bars you see indicates the remaining power. AgfaPhoto POWERCUBE 300Pro can be used
until it is empty but we recommend to recharge when the level is at one bar.
3. Can I charge the AgfaPhoto POWERCUBE 300Pro while supplying power at the same time?
yes. All outputs support simultaneous charging and discharging. Please note, however, that this only
makes sense with a remaining battery capacity of more than 10%. Please also be aware, that if the
battery voltage is less than 13V, the inverter will shut down due to battery cell protection.
4. Can I take my AgfaPhoto POWERCUBE 300Pro on a plane?
No.
The unit provides Modified Sine Wave output, and can be compatible to AC electric appliances that
However, anything that uses an AC motor isn't going to work to full capacity on a modified sine
wave, such as an electrical fan. It will even make the electric appliance arouse some noise.
Appliances like refrigerators, microwaves, and compressors that use AC motors and some delicate
This product is only used for emergency, it cannot replace the normal alternating current, for long-
term use, please adapts the power station specification required by electrical appliances.
AgfaPhoto POWERCUBE 300Pro is not suitable for use with a device with an electric motor.
34
work with sinusoidal waveform (power <100W).
medical equipment should use a product with a pure sine wave inverter.
ATTENTION