aqprox! appPLC5 Gebrauchsanweisung Seite 7

If you hold down the button 5 to 8 seconds assigned to the network
encryption.
If you hold down the button for 10 to 15 seconds makes the adapter
restore factory defaults
Installation and Configuration
Create a network between two PLC logic
1 Connect PLC A and B to a free plug of your home (not possible
STRIPS)
Press the Reset button \ Security PLC to between 5 and 8
seconds. The device will reset with network security.
Press the Reset button \ Security PLC A for less than 3 seconds.
Within 2 minutes, press the Reset button \ Security in PLC B for less
than 3 seconds.
Wait until the connection is complete.
Note: If the connection is successful, the power indicators and data
on both devices permanently lit.
Add PLC to the logical network
Connect PLC C a free plug of your home (not possible STRIPS)
Press the Reset button \ Security PLC C in 5 to 8 seconds. The device
will reset the network security.
7