Preparation; Preparing The Setup Location And The Connections; Installation; Setting Up The Solar Shower - Steinbach Magic Originalbetriebsanleitung

The illustration shows how a solar shower works:
The entire shower body is filled with water and
works in a similar way to an electric water heater
in which the heated water also collects at the top.
If hot water is needed, the faucet
the tank is turned to let in cold water and the
5
water in the top region, which has already been
heated, is pushed out of the tank.
Any pressure that builds up due to the water
heating up in the tank can therefore escape
through the shower head
drip from the shower head when the faucet is
closed.

Preparation

Preparing the setup location and the connections

The shower must be anchored to the ground so that it can be used safely.
The safest place to use the shower is on a smooth, level concrete or wooden floor.
Careful selection and good preparation of the setup location makes it much easier to set up and use the
shower. The following requirements must be met or considered:
- Water supply/drain, attachment and solar radiation
- Sturdy, level, waterproof and slip-proof floor, alternatively the floor element (item no. 049028)
The product can topple.
- A second person who holds the product is required for installation.
To prepare the setup location, proceed as follows:
1. The second person positions the shower at the desired location and secures it so that it cannot
topple over. Mark the drilling points through the holes in the base of the shower.
2. Detach the shower from the base.
3. Drill suitable holes for the selected attachment materials into the floor with an electric drill.
4. Put the attachment material (e.g. wall anchors) into the holes.
The setup location is prepared.

Installation

Setting up the solar shower

Position the solar shower at the prepared setup location. Make sure that the solar shower is pointing in
the correct direction.
The second person supports the shower while you screw the base of the shower into the floor with the
correct attachment materials.

Assembling the solar shower

Using tools can damage the connections. Tighten the individual parts by hand. The screw connection is
water-tight before screwing it in all the way so that the individual parts can be correctly positioned. The
16
at the base of
6
. This causes water to
7
CAUTION!
Risk of injury!
1
5
7
6