jWIN JV-DTV23 Bedienungsanleitung Seite 8

- You can connect additional equipment, such as VCRs, camcorders etc. to your set. However please check with your
manufacturers instruction books for specific information. Make sure all connections are made with both your set and
additional appliance unplugged from the mains to avoid damaging your equipment. Here shown may be somewhat dif-
ferent from your set.
1 1
Connect to Aerial socket
Connect the RF out socket of the VCR to
the aerial socket on the back of the set.
Connect the aerial cable to the RF aerial
in socket of the VCR.
Store the VCR channel on a desired pro-
gramme number using the 'Manual pro-
gramme tuning' section.
Select the programme number where
the VCR channel is stored.
Press the PLAY button on the VCR.
8
All manuals and user guides at all-guides.com
2 2
Watching VCR
- If you connect an S-VIDEO VCR to
the S-VIDEO input, the picture
quality is improved; compared to
connecting a regular VCR to the
Video input.
- To avoid picture noise (interfer-
ence), leave an adequate distance
between the VCR and set.
VCR
Use the INPUT SELECT button on the remote control to select
(If connected to S-VIDEO, select the
Insert a video tape into the VCR and press the PLAY button on the VCR. (See
VCR owner's manual)
< Back panel of the set >
A A V1 V1 A A V2 V2 S-VIDEO S-VIDEO ANT. IN ANT . IN
S-VIDEO
OUT
(R) AUDIO (L) VIDEO
IN
< Back panel of VCR >
AV1 or AV2
S-Video external input source.)
AC INPUT AC INPUT
.