jWIN JV-DTV23 Bedienungsanleitung Seite 32

- Connect the RS-232C input jack to an external control device (such as a computer or an A/V control system) and con-
trol the set's functions externally.
How to connect external control
equipment
Connect the serial port of the control
device to the RS-232C jack on the set.
RS-232C connection cables are not
supplied with the Monitor.
The Monitor remote control and front
panel controls (except main power)
will not be functional if the set is con-
trolled by a PC computer or other
external device.
32 32
All manuals and user guides at all-guides.com
Type of connector; D-Sub 9-pin male
No.
< Side panel of the set >
1
2
3
4
5
6
7
8
9
Communication Parameters
• Baud rate : 115200 bps (UART)
• Data length : 8 bits
• Parity : None
• Stop bit : 1 bit
• Communication code : ASCII code
Pin name
No connection
RXD (Receive data)
TXD (Transmit data)
DTR (DTE side ready)
GND
DSR (DCE side ready)
RTS (Ready to send)
CTS (Clear to send)
No Connection
1
5
9
6