Miele PAC 1045 Gebrauchsanweisung Seite 60

en - Cleaning and care
60
Remove the plug from the socket and ensure that the air purifier is

de-energised.
If the appliance was in operation before it was unplugged, wait ap-

prox. 10 minutes to allow it to cool down fully.
The housing may still be warm immediately after operation.
Remove the screws from the service flap on the rear of the air puri-

fier. Remove the service flap and the pre-filter behind it.
2.
1.
1 2 3
a
Pre-filter (left) with holding plate
b
Contact protection
Remove the screw in the middle (1.) and fold the contact protection

forwards (2.).
Remove the screws from the holding plates of the pre-filters.

Remove the used pre-filters and place them in a sealable bag.

4
3
2
1
a
Service flap
b
Pre-filter (front)
c
Pre-filter (bottom)
Insert the new pre-filters. The flame-scarfed (coloured) side of the

pre-filters must face outwards (in the direction of the air intake
vents).
Screw the holding plates of the pre-filters back into place.

Pull the contact protection downwards and screw it back into place.

Close the service flap and retighten the screws.

4
c
Pre-filter (bottom) with holding
plate
d
Pre-filter (right) with holding
plate
5
d
Pre-filter (left)
e
Pre-filter (right)