Changing The Operating Status; Displaying Operating Values; Deactivating The Keypad Lock - Miele PAC 1045 Gebrauchsanweisung

en - Using the machine
Changing the op-
erating status
Displaying oper-
ating values
Deactivating the
keypad lock
48
If you wish to change the operating status, you can switch between
Ready for operation
CO2 operation ThermoControl active
,
Press the  button repeatedly until you reach the desired operating

status.
Tip: If you wish to clean the filter manually via Miele ThermoControl,
press the  button repeatedly until you reach the
ive
operating status. Relevant pathogens will then be deactivated in
the filter by Miele ThermoControl. After Miele ThermoControl, the fan
keeps running automatically in order to cool down the filter safely,
after which the appliance switches back to the
operating status.
The operating values of the air purifier can be displayed via the
ating values display
menu.
Press and hold the  button for more than 3 seconds.

Operating values display
Operating hours 1245
Time to filter change 523
Miele V01.1 PAC 1080
09.11.2020 Mon 14:28:00
Operating values display
The
Operating values display
Filter saturation 25
Room temp.: 22
ThermoControl temp. 34
09.11.2020 Mon 14:28:00
Press the  or  button briefly to scroll through the pages of the

Operating values display
To exit the operating values display, briefly press the  and  but-

tons at the same time (<1 sec) or wait 10 seconds.
If the display lighting is switched off, the keypad lock is activated. You
can deactivate the keypad lock by holding down the  and  but-
tons for at least 3 seconds.
If no buttons are pressed within 60 seconds of deactivating the
keypad lock, it will be reactivated again automatically.
Flow
, (if selected via option),
and
h
h
menu is now displayed.
%
°C
°C
menu.
Manual operation
Fan run-on
at any time.
ThermoControl act-
Ready for operation
/
Oper-