HIKVISION EXIR Schnellstartanleitung Seite 8

Network Bullet Camera·Quick Start Guide

Improper replacement of the battery with an incorrect type may defeat a
safeguard (for example, in the case of some lithium battery types).

Do not dispose of the battery into fire or a hot oven, or mechanically crush or
cut the battery, which may result in an explosion.

Do not leave the battery in an extremely high temperature surrounding
environment, which may result in an explosion or the leakage of flammable
liquid or gas.

Do not subject the battery to extremely low air pressure, which may result in
an explosion or the leakage of flammable liquid or gas.

+ identifies the positive terminal(s) of equipment which is used with, or
generates direct current. - identifies the negative terminal(s) of equipment
which is used with, or generates direct current.
Fire Prevention

No naked flame sources, such as lighted candles, should be placed on the
equipment.

The serial port of the equipment is used for debugging only.
Hot Surface Prevention
CAUTION: Hot parts! Burned fingers when handling the parts. Wait
one-half hour after switching off before handling parts. This sticker is
to indicate that the marked item can be hot and should not be touched
without taking care. For device with this sticker, this device is intended
for installation in a restricted access location, access can only be gained
by service persons or by users who have been instructed about the
reasons for the restrictions applied to the location and about any
precautions that shall be taken.
Installation

Install the equipment according to the instructions in this manual.

To prevent injury, this equipment must be securely attached to the floor/wall
in accordance with the installation instructions.

Never place the equipment in an unstable location. The equipment may fall,
causing serious personal injury or death.
Power Supply

The input voltage should conform to IEC60950-1 standard: SELV (Safety Extra
Low Voltage) and the Limited Power Source. Refer to the appropriate
documentation for detailed information.

The power source should meet limited power source or PS2 requirements
according to IEC 60950-1 or IEC 62368-1 standard.

DO NOT connect multiple devices to one power adapter, to avoid over-heating
or fire hazards caused by overload.

Make sure the plug is properly connected to the power socket.
6