First Use - CENTROPIX BUBBLE+ Bedienungsanleitung

3. First Use

1. Before wearing the BUBBLE for the first
time, it must be charged. Take the charging
cable and insert it into the BUBBLE
Then plug the other end of the cable into a
suitable USB socket of a mains plug or a
device with a current supply (e.g. computer).
2. When the device is plugged, the light on the
back of the case flashes red once every second,
indicating the is in charging mode.
BUBBLE
When the battery is charged, the light signal
changes to green and flashes every 12 seconds.
The BUBBLE is now charged and switched on.
3. Then, thread the supplied strap (or your own
chain*) through the eyelet on the shell. Use
the strap to hang the BUBBLE around your
neck, with the signal light on the skin side and
the company logo on the outside. Please be
careful when pulling the closed strap over
your head. Tearing of the strap or the eyelet
on the shell is not covered by the warranty
(liability for material defects).
11
.
* Of course, you can also replace the strap with another chain. Please make
sure that a metallic chain has been galvanically interrupted. This means
that the metallic chain leaving the device eyelet is interrupted by a non-
metallic chain link (e.g. near the clasp) or a completely non-metallic strap
can be used, such as rubber, leather, a silk cloth, or a fabric cord.
BUBBLE
Important Notes
You should drink enough water (non-carbonated) or tea daily
so that the body can best respond to the optimized intrinsic
field. You can also wear the BUBBLE
(e.g. every other hour during the day) to get used to it.
Most BUBBLE wearers report that they prefer to take
the BUBBLE off at night.
intermittently
B E T H E C H A N G E
12