Technical Data - AEG DBS 5558 Bedienungsanleitung, Garantie

Vertical Steam function (Vertical Steam)
This can be used to produce a jet of steam in a vertical
direction. This function can be used to remove creases from
hanging clothes or from curtains.
WARNING:
Never point the steam jet at other people. Danger of
burns.
Hang your laundry on a clothes hanger and move the iron to
approximately 2-3 cm away.
How can I replenish the water during operation?
Refill with water before the tank is completely empty.
• Place the iron on the rest (6).
• Set the temperature control to "MIN".
• Remove the mains plug from the socket.
• In order to remove the tank, press the RELEASE button
below the water tank.
• Remove the lime filter cartridge.
• Fill the tank up to the maximum mark. Do not overfill!
• Close the water tank.
• Reinsert the lime filter cartridge and push the tank back
into the base.
• You can now continue ironing.
When you have finished
• Now you can start ironing. Always turn the temperature
control to "MIN" after use and remove the mains plug
(the control lamp in the handle goes off).
• Remove the mains plug from the socket.
• Empty the water tank.
• Allow the device to cool down before you put it away.
Cable storage
Wind the mains cable around the cable groove at the foot
of the stand. Secure the mains cable with the supplied cable
clip. Place the mains plug into a loop of the mains cable to
secure it.
Anti-scale filter
Your steam iron station is fitted with an anti-scale filter. The
anti-scale filter cartridge becomes spent after filtering ap-
proximately 18 litres of water, depending on the hardness
of your water. It then loses its effectiveness and must be
replaced.
• Turn off the appliance.
• Disconnect the mains plug from the mains.
• Remove the water tank.
• Remove the anti-scale filter cartridge.
• Fill the tank up to the maximum mark. Do not overfill!
• Insert a new anti-scale filter cartridge.
• Before turning on the appliance, wait a few minutes until
the new filter cartridge is saturated with water.
NOTE:
If you do not have a new anti-scale filter cartridge, you can
still iron with the used cartridge and distilled water.
Cleaning
WARNING:
• Always remove the mains lead before cleaning!
• Wait until the machine has cooled down completely.
• Under no circumstances should you immerse the
device in water for cleaning purposes. Otherwise this
might result in an electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• Clean the casing with a slightly damp cloth.
• Clean the sole plate and the rest with a slightly damp
cloth.
• Any residual water can remain in the water tank, but
should be poured out if it has been in the tank for a
prolonged period.
Troubleshooting
Fault Possible Cause
Device does not Faulty mains
work socket
Loud noises The tank is
during steam empty
operation
The device Is the electric cir-
suddenly stops cuit overloaded?
working during
operation

Technical Data

Model: ................................................................................DBS 5558
Power supply: .............................................................230 V~, 50 Hz
Power consumption:............................................................ 2200 W
Protection class: .................................................................................I
Maximum filling quantity of the water tank: ...................1.7 Liter
Net weight: ...............................................................................3.3 kg
Subject to technical changes without prior notice!
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance
with the latest safety regulations.
English
31
Remedy
Try another
socket
Check the tank
Check the house
fuse