Silvercrest SGW 860 A1 Kurzanleitung Seite 54

Ask your water utility about the water hardness.
Water hardness
mmol/l
dH
(degree
(milli-
of German
mole per
hardness)
litre)
0–5 0–0.94
6–1 1 1.0–2.0
12–17 2.1–3.0
18–22 3.1–4.0
23–34 4.1–6.0
35–55 6.1–9.8
* When regeneration is carried out during a programme, an additional 2.2 l of water is required,
the energy consumption increases by 0.01 kWh and the programme is extended by 4 minutes.
 Close the appliance door.
 Press the
button (18) to switch on the appliance and make settings.
 Press and hold the P button (17) for approx. 5 seconds.
 Then press the P button (17) several times in accordance with the table above to set the
salt consumption.
 If you do no press any button within 5 seconds, the appliance switches to standby
mode.
54 - English
Regeneration
at every X
programme
sequence*
H1 –
H2 10
H3 5
H4 3
H5 2
H6 1
Salt con-
LED ON/LED OFF
sumption
P must be
pressed
Press 1 x OFF
Press 2 x OFF
Press 3 x OFF
(Factory set-
tings)
Press 4 x ON
Press 5 x ON
Press 6 x ON
Display
ECO
OFF ON
ON OFF
ON ON
OFF OFF
OFF ON
ON OFF