AEG BSS 4822 Bedienungsanleitung, Garantie Seite 27

• Logging on devices (Pairing)
Before you listen to music via the unit, you must pair the
devices.
1. Ensure, that the Bluetooth function is activated in
your player (e.g. mobile phone). For this, refer to the
operation manual of your player.
2. Repeatedly press the /MODE button (2), until the
control lamp (3) blinks blue. Press the button (2) to
switch the device into pairing mode.
3. Chose the Bluetooth menu in your player and
register the device in your player. For this, refer to the
operation manual of your player. The device "AEG
BSS 4822" will show in your player as a selection.
NOTE:
Only one playback unit can be connected to the
speaker. If the speaker is already connected to
another playback unit, the speaker will not appear
in the BT selection menu.
4. Now enter the password "0000" in your player,
depending on the device manufacturers, model, and
software version.
If the activation was done successfully, a beep will sound and
the control lamp (3) will light up blue. If there are problems
during pairing, a low beep will sound.
Please refer to the operating manual of the player for the
further course of action. The control lamp blinks blue during
playback.
If possible, adjust the volume of the external unit to a com-
fortable level.
NOTE:
• Depending on the device manufacturer, you need to
perform the registration (PAIRING) again to connect the
devices.
• In case of problems during repairing of a playback
device, deactivate the WiFi-/ and mobile data function
in your playback device.
• The Bluetooth compatibility cannot be ensured for
devices (e.g. mobile phones) getting released in the
future.
• To ensure an optimal connection, make sure that the
battery of your player is completely charged.
• Some of the mobile phone brands have an energy-sav-
ing mode. Deactivate the energy-saving mode as it can
otherwise result in problems during the data transfer
through Bluetooth.
• To be able to transfer audio data, Bluetooth needs to
stay activated in your player Observe the operation
manual of your player.
NOTE:
• If a mobile phone on which you are playing music
receives a call, the music will be interrupted. Sound
will however not be transmitted via the speakers. After
you have terminated the phone call, the devices will be
connected to each other again. You may have to restart
playback.
Cleaning
CAUTION:
Do not submerge the device in water.
• Before cleaning disconnect from mains power supply.
• Clean the device with a soft damp cloth without deter-
gents.
Troubleshooting
Fault Cause
Unit cannot be Unit crashes
operated. and "hangs".
No audio signal Speaker is not
via the Bluetooth paired to the
connection audio source.
Volume too
low
Speaker cannot Pairing does
be connected not work
Audio source
is switched off
Bluetooth is
switched off
at the audio
source.
Bluetooth
version is not
supported.
English
27
Solution
Disconnect from the
mains for around
5 seconds. Then switch
the unit on again.
Check whether a connec-
tion exists. If necessary,
pair the speaker again to
the audio source.
Increase the volume on
the speaker
Increase the volume on
the audio source.
Check whether the audio
source supports the A2DP
protocol.
Switch on the audio
source
Switch on the Bluetooth
function in the audio
source.
Use a different playback
unit.