Programming Mode - Lacor 69325 Gebrauchs- Und Instandhaltungsanleitung

TIME ENTRY
1.- Press "Time Entry" and the display will show "00:00". Select the required time using the
numbers of the control panel.
2.- Select the required power, pressing "hold 0%"; Defrost 20%"; Med-Hi 50%" and "Med-Hi
70%". Higher percentage represents higher heating level. The default power is at 100%
(PL10).
3.- Pressing the power button twice changes the power to 100% (PL10).
4.- Press "Start" to initiate the cooking.
5.- When the program has finished, you will hear 3 beeps and the microwave will show "END".
6.- Pressing "Stop" during the cooking process puts the microwave into pause mode. Press
"Start" to continue with the process or "Stop" to cancel and return to the prepared mode.
PROGRAM PRESET
The cooking time can be pre-selected in this mode by only pressing one button.
Example (cook at 100% during 2 minutes):
1.- Press "7" when the microwave is in prepared mode.
2.- The microwave will start to cook for 2 minutes, with a discounting timer on the display.
3.- When the program has finished, you will hear 3 beeps and the microwave will show "END".
4.- Pressing "Stop" during the cooking process puts the microwave into pause mode. Press
"Start" to continue with the process or "Stop" to cancel and return to the prepared mode.
NOTE: Pressing any pre-selection button during the cooking will change the established time
to the pre-selected one.

PROGRAMMING MODE

This function allows assigning time and power to any of the preset buttons 0-9:
1.- Open the door and press "1" for 5 seconds. You will hear a beep and the display will show
"ProG".
2.- Press the button (0-9) where you wish to save the programme.
3.- Press "Time Entry" and the display will reflect the saved time. Then introduce the required
time.
4.- Press "hold 0%"; "Defrost 20%"; "Medium 50%" and "Med-Hi 70%" to introduce the required
power. The display will reflect the programmed power, if you press the button two times the
power will change to "PL 10".
5.- Pressing "X2" will show "CF:XX" on the display. The default power is at 80% ("CF:80").
If you need to change the power press buttons 0-9 to introduce the required power.
6.- Pressing "Start" saves the programme in the corresponding selected number.
Example (cook with 70% power during 1 minute and 25 seconds):
1.- Open the door and press "1" for 5 seconds.
2.- Press "3" to save the programme in number "3".
3.- Press "Time Entry" and the display shows "00:00"
4.- Press "1", "2" and "5" to introduce the cooking time.
5.- Press "Med-Hi 70%" and the display shows "PL7"
54